Loading... Please wait...

Wilton C1 Pipe Jaws

Hover over image to zoom

  • Image 1
  • Here is a later model C1 with a deeper pocket. The pocket measures around 1-3/16 and requires a shim. I might make a thicker pipe jaw in the future but as of now I will add the shims at no cost.
  • Image 3
  • Image 4
  • Pipe Jaws with Shims
  • Image 6
  • Image 7
$100.00
SKU:
Pipe-C1
Weight:
1.000 LBS
Shipping:
Free Shipping

 Product Description

A pair of new replacement Pipe Jaws for the Wilton Combination C1 Vise.

I have found out that there are two pocket depths in the C1 vises. I had to make a shim at 3/16 thick for the later model C1 vises. See picture for measuring depth of your pocket. I also added a photo of the shim. If your pocket measures around 1-3/16 deep then let me know and I will add the shims at no cost. If your pocket measures around a inch then you do not need a shim.

A note from a customer that needed shims. My vise is stamped 1 / 73.  On the casting it is a 101039.

No hardware supplied. This jaw can be held in by a set screw on the vise or bolt on your clip on the backside.  You can also use the two pin options like on earlier C1 vises. No clip is supplied.

Heat Treated A-2 tool steel to 54-56 Rockwell.  The colorfull pattern on the serrated jaws happens during Heat Treating when nitrogen is used.

 

 Made in the USA.

                                                Fraction        

Length                                       2-3/4          

Width                                        1-3/4           

Thickness                                 1-1/8           

 Pin Holes center to center.    1-3/4 and .450 in diameter

     

 

 Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!

You Recently Viewed...

 

Copyright 2019 WiltonViseParts. All Rights Reserved.
Sitemap | Bigcommerce Premium Themes by PSDCenter