Loading... Please wait...

Spindle Handles

I make new replacement spindle handles for most vises (Wilton and others) out of 1144 Cold Formed CRS which is as tough as it gets. The shaft acts like a spring, and of course you CAN bend it, but it is much stronger than the original.

Also, here is a link to the steel type I use, if you are interested:  CLICK HERE

Some handles match up with the steel diameters that are available and listed below.  If you need a diameter that is not sold, I can make the hole in your spindle a bit larger to accept the next size up.  I have found that some of the older vises have worn enough that the hole has become oblong and sloppy anyway, so it is best to rework it for a tighter fit.

These handle diameters are available for me to order:

1/4, 5/16, 3/8, 7/16, 1/2, 9/16, 5/8, 3/4, 13/16, 7/8, 1.0, 1-1/8 and 1-1/4.

I can not get this diameter in 1144 steel: 11/16

Shipping exceptions,  boring for larger handles and installing the over size handles:

Your handle will be shipped with one knob end attached and finished so you can heat and peen the other end once it is installed on your spindle. If you prefer that I do it, then I just ask that you clean the paint and other crud off your spindle before mailing it to me. I charge an extra $20 for that service because I honestly do not want to do it.  If you need me to bore out the handle support to the next size handle, then I will charge an extra $20 for the labor and machine time. I will create a special listing and send you a link (don't worry, it's easy).

 If I am mailing back a spindle and handle that does not fit in Large Flat Rate box then I usually make a custom box and always pack the spindle securely.  I've done this for a while, and have figured out the best and safest packing. These are shipped through UPS and usually starts at $25. I will include the specific amount in a special listing for this custom product, and I will cover any additional shipping supplies and packing material. 

If you want to make your own then Here is how I do it.

If interested, contact Kevin:  mountainproduct@gmail.com

Sort by:

Copyright 2019 WiltonViseParts. All Rights Reserved.
Sitemap | Bigcommerce Premium Themes by PSDCenter