Currency Displayed in
End Caps for 4 inch Bullet Vises. These guys will press in and can be easily removed with a 1/2" wooden dowel. The caps are built individually from steel and are not stamped out like the originals, so they can take a beating. You will not have to worry about denting these. Once you hold one in your hand, you'll see what I mean.
This 2 inch End Cap fits a 400, HD and other Wilton Bullets with this diameter end cap.
I suggest taking a die grinder to your inside bore of the End Cap area. Since my vise was a rough casting and had several high spots, I learned to lightly tap the end cap in, and if it hesitates, remove it and polish out the high spots on the vise until it sits in the correct place.
*Important* beating these on could cause the casting (your vise) to crack. Your new End Cap will be fine though!!
The ID is 2 inch and that is what I made the end caps diameter to.
Made in the USA.