Loading... Please wait...

End Caps 1 inch. Fits the Baby Bullet.

Hover over image to zoom

  • Image 1
  • Image 2
  • Image 3
  • Image 4
  • Image 5
  • Image 6
  • Image 7
1.000 LBS
Free Shipping

Temporarily out of stock Please check back at a later date.

 Product Description

End Caps for Baby Bullet Vises.  These guys will press in and can be easly removed with a 3/8" wooden dowel. The caps are built individually from steel and are not stamped out like the originals, so they can take a beating. You will not have to worry about denting these.  Once you hold one in your hand, you'll see what I mean.

I threaded a 1/2:13 hole on the inside so I could hold on to it while polishing the end radius. The Baby's spindle thread is 3/8 diameter, so no issues with the spindle thread pushing out the end cap.

I suggest taking a die grinder to your inside bore of the Baby End Cap area.  Since my vise was a rough casting and had several high spots, I learned to lightly tap the end cap in, and if it hesitates, remove it and polish out the high spots on the vise until it sits in the correct place. 

*Important* beating these on could cause the casting (your vise) to crack.  Your new End Cap will be fine though!!

Check my pictures.  I have left some End Caps unfinished for those of you who are hands on and want to save a few bucks to finish them up how you like.  See the last picture for coupon details.
Made in the USA.

Questions? Contact Kevin:  mountainproduct@gmail.com


 Find Similar Products by Category

 Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!

You Recently Viewed...


Copyright 2019 WiltonViseParts. All Rights Reserved.
Sitemap | Bigcommerce Premium Themes by PSDCenter