Loading... Please wait...

End Caps 1-11/16 diameter. Fits the 3 inch Bullet Vises and others.

Hover over image to zoom

  • Image 1
  • An original.  And then there's mine.
  • Image 3
  • Image 4
  • Image 5
  • Image 6
$45.00
SKU:
end-cap-1-687
Weight:
0.400 LBS
Shipping:
Free Shipping

 Product Description

End Caps for 3 inch Bullet Vises.  These guys will press in and can be easly removed with a 1/2" wooden dowel.  The caps are built individually from steel and are not stamped out like the originals, so they can take a beating. You will not have to worry about denting these.  Once you hold one in your hand, you'll see what I mean.

This 1-11/16 (1.688) End Cap fits a 9300 Wilton Bullet and any others with this diameter.

I suggest taking a die grinder to your inside bore of the  End Cap area.  Since my vise was a rough casting and had several high spots, I learned to lightly tap the end cap in, and if it hesitates, remove it and polish out the high spots on the vise until it sits in the correct place. 

*Important* beating these on could cause the casting (your vise) to crack.  Your new End Cap will be fine though!!

The ID is 1-11/16 inch and that is what I made the end caps diameter to.


Made in the USA.

 Find Similar Products by Category

 Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!

You Recently Viewed...

 

Copyright 2021 Replacement Wilton Jaws and Vise Parts. All Rights Reserved.
Sitemap | Bigcommerce Premium Themes by PSDCenter