A pair of new replacement Serrated Vise Jaws for the 4 inch Cadet, #8140,  9140,  940, 644, 744, 1740 Tradesman, 2040, 2904040 Mechanic's Vise's and the HD Wilton Vises. 

For those of you that have a Model Number, these jaws fit Wilton Vise models listed above.

A-2 Tool Steel is Heat Treated to 54-56 Rockwell. The colorful pattern on the serrated jaws happens during the Heat Treating process when nitrogen is used. After Heat Treating, these jaws are surface ground flat and then squared.

Supplied with (4) 1/4:20 Socket Head Cap Screws.  

A note on the dowel pins:  If your center dowel pin has rusted into the vise and sticks out a bit (which is common), I have added a 1/32 clearance hole that fits over the pin diameter.  That way the stuck dowel will not interfere with the fit of your new replacement jaws.

Made in the USA

Length                                       4.00        

Width                                            3/4         

Thickness                                     1/2        

Distance between screws.        2-3/8        

Screw Centered in width.     

Screw Size                                  1/4